Jet-tools M-708448 Manuel d'utilisateur

OWNER'S MANUALEHVS-80CS Edge Horizontal/Vertical SanderJET EQUIPMENT & TOOLS, INC. P.O. BOX 1349 253-351-6000A WMH Company Auburn, WA 98071-1

10WARNINGRemoving the belt guard exposes more ofthe sanding belt! Replace the belt guardsimmediately after completing any sandingthat requires it’s re

11Platen Lock Tension Adjustment1. Disconnect the machine from the powersource.2. Loosen lock handle by pulling forward (A,Fig. 9) and move motor and

123. Insert the driver with the round shaft,supplied with the machine into the microadjusting nut (A, Fig. 11) and turn awayfrom you to loosen.4. Turn

13Table AdjustmentWARNINGDo not position table below sanding belt!Keep an overlap of at least 1/16” betweentable and sanding belt to avoid materialand

14Table and Motor Assembly

15Parts List For The EHVS-80CS SanderTable and Motor AssemblyIndex PartNo. No. Description Size Qty.1...EHVS80CS-01... Base...

16Index PartNo. No. Description Size Qty.37A...EHVS80-37A... Pin...

17Index PartNo. No. Description Size Qty.109...EHVS80-109... Label... ..

18Stand AssemblyIndex PartNo. No. Description Size Qty.1...TS-0680031... Flat Washer...

19

2This manual has been prepared for the owner and operators of a JET EHVS-80CS Sander. Its purpose,aside from machine operation, is to promote safety t

3WARNING1. Read and understand the entireinstruction manual before attemptingassembly or operation.2. This sander is designed and intended foruse by p

4Grounding InstructionsCaution: This tool must be grounded while in use to protect the operator from electric shock.In the event of a malfunction or b

5230 Volt OperationWARNING!All electrical connections must be done by a qualified electrician!Failure to comply may result in serious injury!If 230V o

6Specifications: EHVS-80CSStock Number...

7Contents of the Shipping Container1. Stand (front)1. Stand (rear)2. Stand (sides)1. Extension Table Assembly1. Extension Cover1. Owner’s Manual1. War

8Assembly1. Remove all contents from the shippingcontainer.2. Clean all rust protected surfaces with a mildsolvent. Do not use paint or lacquer thinne

910. Sanding platen is presently in a horizontalposition. Pull lock handle forward (A, Fig. 3)to unlock platen assembly, tilt sandingplaten to the ver