Jet Tools GH-1440W Manuel d'utilisateur télécharger pdf (Page 7)

7

Uncrating and Clean-Up

1. Finish removing the wooden crate from

around the lathe.

2. Unbolt the lathe from the shipping crate

bottom.

3. Choose a location for the lathe that is dry,

has good lighting, and has enough room

to be able to service the lathe on all four

sides.

4. Place two steel rods or pipes (of sufficient

strength) into four holes (A, Fig. 1) of lathe

stand. Sling the lathe with properly rated

straps. Do not lift by spindle. With

adequate lifting equipment, slowly raise

the lathe off the shipping crate bottom.

Make sure lathe is balanced before

moving.

5. To avoid twisting the bed, the lathe's

location must be absolutely flat and level.

Check for a level condition using a

machinist's precision level on the bedways

both front to back and side to side. The

leveling pads included in the tool box and

thelevelingscrewsinthelathebasewill

help you to reach a level condition. The

lathe must be level to be accurate.

6. Clean all rust protected surfaces using a

mild commercial solvent, kerosene or

diesel fuel. Do not use paint thinner,

gasoline, or lacquer thinner. These will

damage painted surfaces. Cover all

cleaned surfaces with a light film of Mobil

DTE Oil Heavy Medium.

7. Open the end gear door. Clean all

components of the end gear assembly

and coat all gears with Mobilith AW 1.

Close the door.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Commentaires sur ces manuels

Pas de commentaire