Jet Tools J-7020 Manuel d'utilisateur télécharger pdf (Page 17)

Figure 21: Model J-7020 cut-off saw wiring diagram

4. Close the blade cover and secure with four knobs.

Electrical

Observe the following when connecting to the power

source. (The cut-off saw wiring diagrams are provided

in Figures 17 and 18.)

WARNING: JET RECOMMENDS THAT ANY WIRING

INVOLVING HARD WIRING OF THE SAW TO A

BRANCH, OR ANY CHANGE OF VOLTAGE SUPPLIED

TO THE MOTOR BE PERFORMED BY A LICENSED

ELECTRICIAN.

1. Make sure the saw is disconnected from the power

source, or that the fuses have been removed or break-

ers tripped in the circuit in which the saw will be

connected. Make sure you put a warning placard

on the fuse or circuit breaker to prevent accidental

electrical shock.

2. If you are installing the motor power cord into a re-

ceptacle, make sure to use the appropriate plug.

3. If you are using hard-wired connections to a junc-

tion box, connect the wires in the box, and close

the box.

4. Install the fuses or reset the breaker.

5. The saw is now ready for service.

Figure 22: Connection diagram for 1ph motor

115 Volt

220 Volt

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Pas de commentaire

Jet Tools J-7020 Manuel d'utilisateur Page 17