Jet-tools JSG-96 Manuel d'utilisateur

Operating Instructions and Parts Manual Benchtop Disc/Belt Sander Model JSG-96 (shown with optional closed stand 708597) WMH TOOL GROUP 2420 V

10Horizontal Sanding Workstop 1. Loosen the socket head cap screw (A, Fig. 7) so that the sanding belt can be rotated to the horizontal position.

11Belt Tracking Adjustment 1. Connect the machine to the power source. One time quickly turn the machine “ON” and “OFF”. This will allow you to v

124. If the miter slot is not parallel loosen the two socket head cap screws (A, Fig. 13) and adjust for parallel. Tighten the two screws when the

13Dust Collection 1. Hook the sander to a dust collector using a 4” diameter hose and clamp (A, Fig. 16). JET offers a wide variety of hoses, adap

14Troubleshooting Trouble Possible Cause Solution Sander will not start 1. Sander unplugged from wall or motor 2. Fuse blown or circuit breaker tri

15Disc Sander Assembly Breakdown

16Parts List For The JSG-96 Sander Disc Sander Assembly Index Part No. No. Description Size Qty. 1...JSG96-101...

17Index Part No. No. Description Size Qty. 51...JSG96-151... Screw...

18Belt Sander Assembly Breakdown

19Belt Sander Assembly Index Part No. No. Description Size Qty. 1...JSG96-201... Bracket...

2This manual has been prepared for the owner and operators of a JSG-96 Sander. Its purpose, aside from machine operation, is to promote safety throu

20Index Part No. No. Description Size Qty. 54...TS-0561011 ... Hex Nut...

21Open Stand Breakdown

22JSG-96 Open Stand Assembly Index Part No. No. Description Size Qty. 1...JSG96-401... Stand Top (front and rea

23Closed Stand Breakdown

24Closed Stand Assembly Index Part No. No. Description Size Qty. 1...JSG96-301... Base...

3 WARNING Wear eye protection. Always keep guards in place and in proper operating condition. Do not operate the machine without the guards for an

4• ALWAYS DISCONNECT THE MACHINE FROM THE POWER SOURCE BEFORE SERVICING. • REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure the switch is i

5Grounding Instructions Caution: This tool must be grounded while in use to protect the operator from electric shock. In the event of a malfunctio

6Specifications JSG-96 Stock Number...

7Contents of the Shipping Carton 1. Sander 1. Sanding Belt 1. Sanding Disc 2. Tables 1. Center Point 3. Handles 2. 5/16” Flat Washers 1. Miter Gaug

8Assembly CAUTION Machine is heavy! Use care when lifting out of the shipping carton and moving to a final location. Stand or bench must be stab

9Sanding Belt Table Adjustment WARNING Always disconnect the sander from the power source before servicing or making any adjustments. Failure to com