Jet-tools JWL-1442VS Manuel d'utilisateur télécharger pdf (Page 10)

Stand Legs (optional accessory)

1. At this point the headstock, tailstock and tool

rest should be removed. With help from

another person, lift the lathe bed and place

onto a workbench.

2. Angle lathe bed so that stand leg mounting

holes are accessible, see Figure 2.

3. Thread adjustable feet (A, Fig. 2) into stand

leg (B, Fig. 2). There is a flat spot on the

shaft near the foot that will accommodate a

wrench. Thread a hex nut (C, Fig. 2) onto

shaft and leave loose for now.

4. Mount the leg to lathe bed with four 5/16” flat

washers and four 5/16”-18 x 1-1/2” hex

socket cap screws (D, Fig. 2).

5. Repeat for the other leg.

6. Adjust the feet so that the lathe rests evenly

on the floor, and tighten the nuts.

7. Reinstall headstock, tailstock and tool rest.

Stand Shelf

You can make an extra shelf that rests between

the legs if you wish, see Figure 3. It will be

useful for storing lathe accessories, or adding

sand bags for some extra weight. The two 2x4’s

should be 55-3/4” long. The plywood should be

ripped into two equal pieces 27-13/16”L x 17”W

so that it can be assembled between the legs.

Use screws to attach the plywood to the 2x4

supports.

Controls & Features

E. Headstock Lock Handle: (E, Fig. 4)

Locks the head in position. Unlock the

handle to position the head in any location

along the lathe bed. Tighten handle when

properly positioned.

F. Headstock Indexing Pin: (F, Fig. 4)

Turn the knurled knob counter-clockwise to

unlock the plunger. Pull the knob out to

release the headstock. Unlock the

headstock-locking handle and rotate the

headstock. Turn knurled knob clockwise until

it stops to lock plunger.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Pas de commentaire

Jet-tools JWL-1442VS Manuel d'utilisateur Page 10