Jet-tools JWL-1442VS Manuel d'utilisateur télécharger pdf (Page 5)

Grounding Instructions

This tool must be grounded while in use to protect the operator from electric

shock.

In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric

current to reduce the risk of electric shock. This tool is equipped with an electric cord having an

equipment-grounding conductor and a grounding plug. The plug must be plugged into a matching outlet

that is properly installed and grounded in accordance with all local codes and ordinances.

Do not modify the plug provided. If it will not fit the outlet, have the proper outlet installed by a qualified

electrician.

Improper connection of the equipment-grounding conductor can result in a risk of electric shock. The

conductor, with insulation having an outer surface that is green with or without yellow stripes, is the

equipment-grounding conductor. If repair or replacement of the electric cord or plug is necessary, do not

connect the equipment-grounding conductor to a live terminal.

Check with a qualified electrician or service personnel if the grounding instructions are not completely

understood, or if in doubt as to whether the tool is properly grounded. Use only three wire extension cords

that have three-prong grounding plugs and three-pole receptacles that accept the tool’s plug.

Repair or replace a damaged or worn cord immediately.

115 Volt Operation

As received from the factory, your sander is ready to run at 115-volt operation. This sander, when wired

for 115 volts, is intended for use on a circuit that has an outlet and a plug that looks the one illustrated in

Figure A. A temporary adapter, which looks like the adapter as illustrated in Figure B, may be used to

connect this plug to a two-pole receptacle, as shown in Figure B if a properly grounded outlet is not

available. The temporary adapter should only be used until a properly grounded outlet can be installed by

a qualified electrician. This adapter is not applicable in Canada. The green colored rigid ear, lug, or tab,

extending from the adapter, must be connected to a permanent ground such as a properly grounded

outlet box, as shown in Figure B.

The use of an extension cord is not recommended. However, if you must use one make sure your

extension cord is in good condition. Be sure to use one heavy enough to carry the current your machine

will draw. An undersized cord will cause a drop in the line voltage resulting in power loss and overheating.

The following table shows the correct size to use depending on the cord length needed and the

nameplate ampere rating. If in doubt, use the next heavier gauge. Remember, the smaller the gauge

number, the heavier the cord.

Volts Total Length of Cord in Feet

120V 25 50 100 150

AWG

12-16

Amps

14 12 Not Recommended

1 2 3 4 5 6 7 8 9 10 ... 31 32

Pas de commentaire

Jet-tools JWL-1442VS Manuel d'utilisateur Page 5