Jet-tools DC-1100A Manuel d'utilisateur

OWNER'S MANUAL DC-1100A Dust Collector JET P.O. BOX 1349 Phone:253-351-6000 WMH Tool Group Auburn, WA 98071-1349 Fax: 1-800-274-6840 www

104. Attach three support brackets (A, Fig. 4) to the base using six M8 x 16 hex cap bolts and six M8 flat washers (B, Fig. 4). Hand tighten only at

117. Slide the bag hanger hook (A, Fig. 7) through the top loop of the filter bag. Insert the hanger into the hanger bracket. Thread the retainer s

12Maintenance WARNING Never perform maintenace on this machine before turning switch off and removing plug from power source, unplug. Failure to comp

13Parts Breakdown

14Parts List for the DC-1100A Index Part No. No. Description Size Qty. 1...411035W ... Impeller Housing...

15Wiring Diagram

2This manual has been prepared for the owner and operators of a JET DC-1100A. Its purpose, aside from machine operation, is to promote safety through

3 WARNING 1. Read and understand the entire contents of this manual before attempting assembly or operation. Do not use this machine until proper

4Grounding Instructions Caution: This tool must be grounded while in use to protect the operator from electric shock. In the event of a malfunction

5230 Volt Operation If 230V, single phase operation is desired, the following instructions must be followed: 1. Disconnect the machine from the pow

6On-Off Switch Padlock Model No. PB-1, Stock No. 709012 To safeguard your machine from unauthorized operation and to avoid accidental starti

7Specifications: DC-1100A Stock Number...

8 WARNING Read and understand the entire contents of this manual before attempting assembly or operation of the dust collector! Failure to comply may

9Assembly 1. Install four casters to the under side of the base as pictured in Fig. 1. Thread the hex nut (B, Fig. 1) onto the caster shaft. Then